Product installation

STARPOWER LED UNDERGLOW INSTALLATION




Prior to installing the system, make sure both the unit and remote control included are working.


The controller box has been labeled with a red and black wire (black=ground  red=12v). When viewing from the top sus garage sticker the wires can be located as follows: black on the left and red on the right. Ensure that the wires are facing in the right direction.

 
insert wires in the slots and tighten the screws under the box to secure the cables in place.
Apply ground to black and a 12v source to red

Once that the system has been confirmed to be working properly start the led strip installation

First find your cable routing
(The 3 wires from the led strips are shipped connected, but they can be disconnected to make it easier to route the wiring of each individual strip.)
Once you have found all of your cable routing connect all 4 strips back to the box white green and red to their respective slot as shown.

To install the led strip under the car locate a flat and even surface. This surface must be clean and dry  in order for the provided double sided tape to adhere properly.

The led strip is shipped with a pre installed tape to protect it from dirt and debris. This is not the tape that will be used to attach the led lights to the vehicle.
The pre installed clear adhesive must be removed. Following that, the heavy duty double sided 3m tape that is provided must be applied.  


Connecting the box
You can tap the box voltage to a wire that provides voltage when the key is open
So that the leds are not on all the time

If you want your underglow on while the car is off the leds can be wired directly to the battery  with a push button  this is optional and hardware to do this is not provided



SUSSY HEARTS


Led sussy heart